The view hat works for looking around, and the twist grip turns the rudder left or right. It even has an extra button for your thumb on the left side of the handle. But one annoying thing is that it's built for people who fly right handed, and I'm always flying with my left hand. It gives me features that the Attack 3 never had, such as the view hat and twist grip. But after a few months now the x-axis keeps going out of line and it's really annoying. It has 11 programmable buttons and a slider on the back which you can roll and control throttle. Throttle is very easy to control and it is quite a comfortable stick. FG has had no trouble reading or running it. I've had this stick for a few months now. Useless if you plan on getting precision for anything I'll write one about mine to give you an idea: Post a picture of your controller (doesn't have to be your exact one, but an image of the same model) Tell us the pro's and con's of your controller, and tell us how well it works with your game, how much does it cost? And give it a score out of 10. You may just get used to it without adjustment.Tell us about your controller, write a little review. It may be necessary to go into your computer's system preferences to slow down the speed of your mouse's actions, but that is optional. Make sure your handle is centred, then press 5 on your numpad to centre all your aircrafts control surfaces.Place your handle so the upper half-sphere sits centrally in the hole in your base unit, making sure the lower end of the small dowel goes through the hole in the top of the lower half-sphere.Place lower half-sphere over your computer mouse, making sure the end of your mouse which normally faces away from you is now facing towards you.Optional: If you wish to tidy things up a bit, you could trim off some of the upper half-sphere to lessen the amount of filler needed, but be careful not to remove too much, because this might allow the edge to rub/catch in the hole.Īfter you have used your mouse to do the necessary set up for your flight (If you are fortunate enough to have a spare mouse, you can take the necessary actions with the other one provided you have a spare USB slot): Affix some small nails near the bottom of your handle to act as anchors inside the filler, then place your handle centrally in the upper half-sphere and fill with setting material (plaster or foam etc).Put some glue into the hole you drilled in the bottom of your handle, then push in the smaller dowel. ![]() Ascertain how much the smaller dowel needs to be shortened, make allowance for both the bottom of the dowel having to connect with and move the lower half-sphere (yet still clear the top of your mouse), and the other end needing to be pushed into your handle.Drill a hole in your base, large enough for the upper half-sphere to swivel in all directions, but not large enough for it to pass through. ![]() The base needs to be wide enough to allow plenty of movement in all directions during use. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |